珠穆朗玛峰高程与板块构造运动问题

喜马拉雅山是由印度板块和欧亚板块相碰撞而形成,这已被当代多数有关科学家所认识。一些测量数据也表明喜马拉雅山现在仍在快速隆升。而喜马拉雅山主峰——珠穆朗玛峰的高程的测定,也成为当代地学界的热点。本文结合最新资料对精确测定珠峰高程的一些问题,诸如水准基面、峰顶标志和积雪等进行了讨论。     

青藏高原东部牧区雪灾的环流型及水汽场分析

冬、春季雪灾是青藏高原东部牧区重要的灾害性天气。本文利用历史天气图和国家气象中心T106L19全球模式的分析值格点资料，分析了青藏高原东部牧区近20年来冬，冬季降雨的天气形势和水汽场。结果表明，北脊南槽型、乌山脊型、阶梯槽型和国境槽型是造成高原东部牧区降雪的四类主要环流型；在高原东部牧区强降雪天气过程时气柱可降水量有明显增加，记要降雪区与水汽通量辐合区吻合，主要水汽来自孟加拉湾地区。     

A Note On Surface Humidity Measurements In The Cold Canadian Environment

In the cold Canadian environment, humidity measurements can be verydifficult to conduct. In this brief communication, humidity observationstaken by two different sensors at six remote Canadian Arctic locations arecompared. The observations collected by Vaisala HMP35CF sensors displaya strong tendency toward the ice saturation point whereas dew cell instrumentsexhibit significantly lower values of relative humidity with respect to ice (RH_i).Humidity data collected by HMP35CF hygrometers are therefore unreliable sincethey are subject to persistent icing that lead them to record values of RH_i near 100%, irrespective of the air temperature. The high humidity bias emerges atmeteorological stations mounted with the HMP35CF probes since these instrumentsare usually neither sheltered nor heated, and are not attended to at regular intervals. Thus, great care must be taken in utilizing humidity data recorded by HMP35CF sensors across the network of climate autostations in Canada.     

Velocity profile of a sand cloud blowing over a gravel surface

Particle dynamic analyzer (PDA) measurement technology was used to study the turbulent characteristics and the variation with height of the mean horizontal (in the downwind direction) and vertical (in the upward direction) particle velocity of a sand cloud blowing over a gravel surface. The results show that the mean horizontal particle velocity of the cloud increases with height, while the mean vertical velocity decreases with height. The variation of the mean horizontal velocity with height is, to some extent, similar to the wind profile that increases logarithmically with height in the turbulent boundary layer. The variation of the mean vertical velocity with height is much more complex than that of the mean horizontal velocity. The increase of the resultant mean velocity with height can be expressed by a modified power function. Particle turbulence in the downwind direction decreases with height, while that in the vertical direction is complex. For fine sands (0.2–0.3 mm and 0.3–0.4 mm), there is a tendency for the particle turbulence to increase with height. In the very near-surface layer (<4 mm), the movement of blown sand particles is very complex due to the rebound of particles on the bed and the interparticle collisions in the air. Wind starts to accelerate particle movement about 4 mm from the surface. The initial rebound on the bed and the interparticle collisions in the air have a profound effect on particle movement below that height, where particle concentration is very high and wind velocity is very low.     

Distribution and effectiveness of nivation in Mediterranean mountains: Peñalara (Spain)

Snow accumulation is responsible for geomorphic and biogeographic processes taking place in the southern sector of the Peñalara massif in central Spain (40°51′N, 3°57′W; max. altitude 2428 m at Pico de Peñalara). This work compares the intensity of nivation on the eastern slope, leeward of the prevailing westerly winds and heavily eroded by glacial activity during the Pleistocene, to that of the western slope on the windward side, unaffected by glacial erosion and completely covered by a thick weathering mantle. On the eastern slope, nivation is effective only where the weathering mantle is exposed or on morainic formations. It does not occur on the landforms derived from glacial erosion. In contrast, the western side shows almost no evidence of snow action except where catastrophic mass movements have altered the regularity of the slope. During the post-glacial epoch, nivation cirques formed in the scars left by mass wasting. In the last 30 years, spring temperatures have increased and this activity has diminished. The pattern of evolution observed at Peñalara can be extrapolated to other Mediterranean mountains with similar characteristics such as marginal glacial activity during the Pleistocene, unconsolidated formations on the summits caused by chemical weathering, and dry, hot summers that can increase the effectiveness of nivation.     

利用NOAA AVHRR数据研究北半球雪盖气候学特征

利用NOAA卫星图像,研究了北半球、欧亚、北美和青藏高原雪盖气候学特征及其变化趋势.指出北半球、欧亚和北美雪盖气候变化趋势基本一致,年均雪盖面积在1987年前后明显下降; 而青藏高原雪盖面积在1984年后明显下降,说明青藏高原雪盖的年际变化与北半球及欧亚、北美不完全一致.     

被动微波遥感估算雪水当量研究进展与展望

被动微波遥感可以透过云层，全天候地提供地表一定深度的信息。星载被动微波遥感传感器的时间分辨率很高，在冰冻圈动态研究中有着重要的地位。在最近的二三十年中，大量被动微波遥感的应用都是在美国、加拿大、欧洲等地，而我国在这方面的研究相对较少。首先介绍了被动微波遥感数据在监测积雪方面的国内外研究进展，对现存的雪水当量（SWE）估算算法（和模型）的适用性进行讨论。然后，详细讨论了我国西部的青藏高原地区雪水当量的估算，阐明了利用SSM／I数据估算青藏高原地区雪水当量的复杂性，并指出了其复杂性产生的原因，提出了解决问题的方法，为该地区积雪动态的进一步研究提供了理论依据。     

沈阳地区沙尘天气分析

本文总结了沈阳地区沙尘天气的时空分布特点，从天气条件、地表自然条件(沙源)两方面分析了沈阳地区沙尘天气的成因，总结了沈阳地区预报沙尘天气时应参考的5个因素。     

近50年中国地面气候变化基本特征

采用国家基准气候站和基本气象站的地面资料,系统地分析了中国大陆地区1951年以来近地表主要气候要素演化的时间和空间特征。结果表明,中国近50 a来年平均地表气温变暖幅度约为1.1℃,增温速率接近0.22℃/(10 a),比全球或半球同期平均增温速率明显偏高。地表气温增暖主要发生在最近的20余年,其季节和空间特征与前人分析结论基本一致。降水量变化趋势对所取时间段和区域范围敏感。1951年以来全国平均降水量变化趋势不明显,但1956年以来略有增加。降水变化的空间特征明显而相对稳定,东北北部、包括长江中下游的东南部地区和西部广大地区降水增加,而华北地区以及东北东南部和西北东部地区降水明显减少。分析还发现,近50a来全国平均的日照时数、平均风速、水面蒸发等气候要素均呈显著下降趋势,但积雪地带的最大积雪深度却有所增加。中国日照时间和水面蒸发量变化的空间特征很相似,减少最明显的地区均发生在华北和华东,新疆次之。影响中国年代以上尺度气候变化的因子错综复杂,人类活动引起的大气中温室气体浓度增高可能在一定程度上影响了中国近50 a来的气候,但考虑到尚存的不确定性,目前仍不能给出明确结论。中国东部大部分地区日照时间和水面蒸发量减少可能均起源于人为排放的气溶胶影响,平均风速减弱也有利于水面蒸发量下降,而在西部地区云量和降水量的变化可能更重要。     

Snow loads on wire mesh and cable net rockfall slope protection systems

Snow load on mesh systems is complicated by many factors. This paper presents field instrumentation data on snow load variation with temperature, snowfall and snow depth on a mesh system. It was found that snow load pattern on mesh systems changed with temperature even without variation in snow depth. It reached its maximum value when the temperature rose just above freezing to melt the interface. The field data was used to formulate appropriate snow load models for the various conditions of temperature in the field. The snow load models were used to study the performance of a number of mesh systems in North America and estimate the interface friction that was prevalent for the different surface conditions.